Castrol Magna MO 59
VISCOSITY - ISO 9
Castrol Magna MO 59 Moulding Oil
Castrol Magna MO 59 (previously called Castcon™ 59) is a special moulding oil, for all types of moulds and forms used in the building industry. Especially suitable base oils conform to the application, ensuring the best separation effect, and providing a high protection against corrosion. The base oils also give concrete a smooth, clean and nonporous surface. In the case of an operation interruption, this product also provides sufficient wetting.
Magna MO 59 is especially economical because of its minimal consumption, and the single application extends the service life of moulds and case-hardened forms.
Castrol has successfully submitted this product to the strict requirements of the high-quality standard DIN EN ISO 9001. This certification gives you additional safety assurance with this product’s quality and the service that can be expected from Castrol.
Castrol Magna MO 59 can be used on all existing moulds and forming materials (steel, wood and plastic), with or without the steam curing process.
Viscosity | 9 mm/s² at 40°C |
---|---|
Oil type | Mineral |
Product type | Lubricating Oils |
Applicable to these sectors | Machinery |
The conditions for the success and efficiency of all mould works, is the quality factor of the moulding oil, and it being properly applied. It’s important that the moulds surface is oiled on a regulated basis. In addition, it’s to be applied in a smooth coating and not heavily, unless there is an increased pit formation. In the case of pitting, appling Magna MO 59 in spray form is preferred over brush application. Wood and plastic moulds should be oiled immediately before being used. Metal plates and metal moulds should be oiled before and after being used.
This product was previously called Castcon 59. The name was changed in 2015.
All packages should be stored under cover. Where outside storage is unavoidable drums should be laid horizontally to avoid the possible ingress of water and damage to drum markings. Products should not be stored above 60°C, or exposed to hot sun or freezing conditions.